Spectra D100 Case Fans RGB Not Working

[TreeCrawler]

So I built my first PC but am having trouble getting the RGB case fans working. They came with the Rosewill Spectra D100 case and are all connected (6-pin connection) to a fanhub.

 

MB: Asus Tuf Gaming Plus WiFi

PSU: EVGA 850GA Supernova Gold (850W)

 

I figured out how to power the fans (a molex cable that is a 4-pin connected to the hub), but don't know why the RGB is not working. There is another 2-pin on the hub that I assume is connected to the front of the case (because the case itself has the RGB controls on the front) although it says LED SW but is connected to the RESET part on the fanhub. 

 

The PSU had a cable that connected the PSU to 4 female molex cables so I used those to connect to the fanhub. After I assembled everything, I powered it on and everything but the RGB worked properly - fans were spinning, but they didn't light up although I pressed the LED button on the case. 

 

I couldn't find much online about this (they just say connect to power properly, etc). Any ideas? If anyone else has used this case, what did you do?

[thrasher_565]

40 minutes ago, TreeCrawler said:

So I built my first PC but am having trouble getting the RGB case fans working. They came with the Rosewill Spectra D100 case and are all connected (6-pin connection) to a fanhub.

 

MB: Asus Tuf Gaming Plus WiFi

PSU: EVGA 850GA Supernova Gold (850W)

 

I figured out how to power the fans (a molex cable that is a 4-pin connected to the hub), but don't know why the RGB is not working. There is another 2-pin on the hub that I assume is connected to the front of the case (because the case itself has the RGB controls on the front) although it says LED SW but is connected to the RESET part on the fanhub. 

 

The PSU had a cable that connected the PSU to 4 female molex cables so I used those to connect to the fanhub. After I assembled everything, I powered it on and everything but the RGB worked properly - fans were spinning, but they didn't light up although I pressed the LED button on the case. 

 

I couldn't find much online about this (they just say connect to power properly, etc). Any ideas? If anyone else has used this case, what did you do?

so you powered it on and connected the led button to the hub and pushed the button?