Petg beta build work still in progress...

[Shogunluffy_1982]

Amd ryzen 7 3700x

Asus rog x370 crosshair VI hero

Gskill trident z rgb 16gb 3600 ddr4

Msi gaming x nvidia gtx 1060 6gb

Sandisk ultra 2 120gb ssd boot

Seagate barracuda 3tb hdd

Seasonic focus gold 750w

Lianli lan cool one digital gold 

Ek classic rgb loop changed 240 rad to 360 and gpu waterblock!

Will upgrade psu and gpu later on and redo the petg that went a little bad and get a missing barrow fitting to replace the black one still not the way i wanted it to look yet as it's my first full petg build...

[Shogunluffy_1982]

[Shogunluffy_1982]

[For Science!]

8 hours ago, Brass_01 said:

 

 

This is only my opinion, so take is as you will, but I find the fact that you have a lot of tubes crossing over each other on the right side of the case a little bit too busy. Since it looks like you are able to flip the radiator so the ports are on the back side (at the cost of the rear exhaust fan, but you don't need it). You could consider having a more parallel arrangement of tubing. The dotted line indicates the run behind the GPU going to the radiator.

 

[Shogunluffy_1982]

13 hours ago, For Science! said:

This is only my opinion, so take is as you will, but I find the fact that you have a lot of tubes crossing over each other on the right side of the case a little bit too busy. Since it looks like you are able to flip the radiator so the ports are on the back side (at the cost of the rear exhaust fan, but you don't need it). You could consider having a more parallel arrangement of tubing. The dotted line indicates the run behind the GPU going to the radiator.

 

Like i said still in progress and never know i still can make changes if i thinks it's needed i found the missing barrow fitting i forgot i had one more and i need to order more petg and fans too and way more coming after it's like the never ending build this project has turn into and peoples advice is always welcome  it doesn't mean il do as some say but it gives me ideas never know?

[Shogunluffy_1982]

On 11/2/2020 at 6:34 AM, For Science! said:

This is only my opinion, so take is as you will, but I find the fact that you have a lot of tubes crossing over each other on the right side of the case a little bit too busy. Since it looks like you are able to flip the radiator so the ports are on the back side (at the cost of the rear exhaust fan, but you don't need it). You could consider having a more parallel arrangement of tubing. The dotted line indicates the run behind the GPU going to the radiator.

 

I was planning a petg rebuild with a new video card eventually so i will probably change some things too like the radiator i found out it would probably be better to change the direction too.

[Shogunluffy_1982]