What are your pump/fan speeds?

[MoonFrost]

Out of curiosity in your loops, what are your speeds? I have 6 fans in total. 1 rear exhaust, 2 top exhaust pushing through a slim 240 radiator, and 3 intake fans in front, pushing through a slim 360 radiator. Single loop cooling my 8700k 1.29v 4.9Ghz, 1080ti @ 2025Mhz and vrm water block.

 

Pump is an ek d5, static 3800rpm (I forgot what % that is in bios) 

 

I have my fan curve set to measure gpu temp, as my 8700k has a 10-20c swing in spike temps, and I don't have a fluid temp sensor. I believe my idle fan speed starts at 700rpm at idle 30c gpu temp, and ramps up to 1500rpm at load of 50c.

 

Just looking to compare what others have. 

[W-L]

7 hours ago, MoonFrost said:

-SNIP-

I personally keep everything as low as possible for noise as I have an excess of rad space. My D5 pump is set to the lowest setting with the fans never going past 750RPM even under full load. 

[Neo-revo]

i run my d5's at 3, both, and fans i run at 9v on rads   3x140 and 4x120.    have 3x120 intake on rad case and  5x140 intake lower case PP exhaust assisted by rads

[B4Quattro]

My radiator fans run 650 rpm and my Aquastream XT pump runs 3840 rpm (64 Hz) for 90 - 95 l/h of flow.

[ewitte]

I dropped my D5 rpm 20% to about 3800-3900 RPM (BIOS is set to 90%).  I'm unable to hear it even at 100% but I wasn't getting benefit so I dropped it to save a bit on heat getting dumped into the loop. Fans run about 900RPM.

 

I will add another 360mm rad to my 420mm if I add the GPU in though then I may increase the pump speed.

[SolarNova]

My D5 Varo is on its max setting (5). isnt noisy at all so..

My fans. I have push/pull on one rad and pull on the other 2. They are all around 1000 RPM to keep noise down. Though i admit , at the time i didnt know much about fans and i wish i had just got 8 Noctua NF-F12's ..would be able to run them faster

My fans are a mix of Bitfenix Specter Pro's , Silverstone SST AP121's, and Scythe Gentle Typhoons. All of which noise wise im not to impressed with.