Help with repair.

[Jengo]

Hello.

I recently got hold of a creative inspire T3130 2.1 system. However it does not have the "remote control". I am therefor trying to bypass this controller.
If there is anyone who has experience with this or thinks they can help, it would be much appreciated.

Bottom left of the image (I know it does not tell you much)
There is a connector with 5 wires, this is the that goes from the remote to the amp.. (from top to bottom)

Black = signal ground.
Red = Signal right.
White = Signal left.
Blue = VO (I don't know what this is)
Yellow = ST (I don't know what this is either)

 

[Jengo]

A picture from the front.

[krishnarajsr]

Hi. Did you sort the issue ?

 

I need a small help . Could you dens the values of components in this area. My board got burned in that area

[H713]

Which part(s)? Most of the resistor color codes can be read from that image. The existing caps on your board should still be readable. Zeners are going to be harder - hopefully you can read a number off the package if they're bad. Transistors should still be readable unless it went down so hard to blow the cases apart. 

 

The OP is probably long gone - this thread is from 2017.