Tuner light help

[8uhbbhu8]

so i picked up an antenna tuner recently which works flawlessly for my use but I found out that the light for the meter is not working. I opened it up and both wires to it and the switch are disconnected. I am terrible at reading schematics and translating them to the pcb so i need some help with this. Can anyone out there let me know where thes 2 wires need to connect to? The red wire is already connected to the switch and the white wire is connected to the central point between the other 2 white wires between c3 and c4

 

Here are both sides of the pcb:

Here is the schematic:

 

[Lolucoca]

I would try to solder it on and see what happens  

[8uhbbhu8]

21 hours ago, Lolucoca said:

I would try to solder it on and see what happens  

Honestly I would do that normally (well not solder but put the wires through random holes i think would match up and see if it works) But since this is a (for me) relatively expensive piece of equipment that i bought I don't want to damage it

[Lolucoca]

Or maybe probe the holes with a multimeter first to see if there's any voltage potential on them