Corsair LNP and Link

[BoilInBagRis]

So I've been running the RGB haven setup on a previous rig which is the Commander, LNP and a 6x LED hub.

Everything was working just fine when I ran it on my Prime X370 Pro along with a 1600. The rest of the system is the same at the moment but the LNP doesn't register for config in Corsair Link.

It does however get recognized by the Link software under the "devices" tab which is weird, the computer recognizes it as well and I've been trying with resetting the LNP, disconnecting it through software as well as physically disconnect it but every time I start up Link I get like a 1 second flash of having it up in the menu and ready for config before it disappears and all I can adjust is the Commander and its' fans

[A Silver]

So you have the commander pro and the lighting node pro? You only need one. I have the LNP with 4 led strips on channel 1 and the 6 fan hub on the other channel. If you have the commander pro, you don't need the LNP and if you have the LNP you don't need the commander pro.

[BoilInBagRis]

3 minutes ago, A Silver said:

So you have the commander pro and the lighting node pro? You only need one. I have the LNP with 4 led strips on channel 1 and the 6 fan hub on the other channel. If you have the commander pro, you don't need the LNP and if you have the LNP you don't need the commander pro.

I have the commander pro and the LNP because I have the need for that many LED ports. 

[A Silver]

Ok, have you reinstalled the firmware? I had an issue with my LNP not working every so often and reinstalling the firmware seemed to help

[BoilInBagRis]

1 minute ago, A Silver said:

Ok, have you reinstalled the firmware? I had an issue with my LNP not working every so often and reinstalling the firmware seemed to help

Sorry if the last answer was a bit sharp, that was not my intention. I had a pretty specific vision of how my computer would look and how the LED strips along with the fans would run their light in different directions etc. and that's why I needed to have more than the 2 LED ports on the Commander.

 

Regarding the firmware, I have been locked out from deleting it for some reason, assuming that you're referring to the specific LNP fw. I have reinstalled Link a couple of times to see if it would help but well, it didn't