Push or pull in my AIO

Dispentry · December 20, 2016

Hey all,

I ordered a Cooler master seidon 120 v2 (as starter) because I want to increase the longevity of my components by reducing heat.

I will be putting it in a zalman z9 neo, which has a front 280 and top 240 slot (and 120 rear) and I was wondering what to do.

I wanted to put it in the rear exhaust slot. Is this a good idea? And should i put the fan in push or pull?

Any help woud be appreciated. Thanks.

Joshua Ondangan · December 20, 2016

well anything goes. if it's as exhaust I kinda like it as pull (pulling air from the case) so it will be easier to clean lol. just take a brush and brush it away.

Energycore · December 20, 2016

Pull is easier to clean

But you can put a screwable dust filter on the fan if you put it on push, and clean that.

Push and pull both have pretty much the same performance.

Joshua Ondangan · December 20, 2016

also if you use pull configuration you should only be using 4 screws unless your screw is asian then might as well go push with dust filter. but if you got no dust filter then just go whichever way you think looks pretty.