Intel MLC for memory latency and bandwidth

[speed258]

Hello I want to measure my rams(its DDR3 SODIMM PC3-12800 800 Mhz 2GB) latency and bandwidth, so I found Intel MLC which provides quite powerful options, but there is too many of them currently I'm using this option: 

mlc.exe ./mlc --max_bandwidth -b18000000 -t2 -L -m0x1

And then output is:

Measuring idle latencies (in ns)...
                Numa node
Numa node            0
       0          60.2

Measuring Peak Injection Memory Bandwidths for the system
Bandwidths are in MB/sec (1 MB/sec = 1,000,000 Bytes/sec)
Using all the threads from each core if Hyper-threading is enabled
Using traffic with the following read-write ratios
ALL Reads        :      15941.7
3:1 Reads-Writes :      14625.7
2:1 Reads-Writes :      14439.6
1:1 Reads-Writes :      13993.7
Stream-triad like:      14984.5

Measuring Memory Bandwidths between nodes within system
Bandwidths are in MB/sec (1 MB/sec = 1,000,000 Bytes/sec)
Using all the threads from each core if Hyper-threading is enabled
Using Read-only traffic type
                Numa node
Numa node            0
       0        15919.5

Measuring Loaded Latencies for the system
Using all the threads from each core if Hyper-threading is enabled
Using Read-only traffic type
Inject  Latency Bandwidth
Delay   (ns)    MB/sec
==========================
 00000  121.06    13919.7
 00002   89.72    14762.0
 00008   87.26    14835.0
 00015   87.81    14548.7
 00050   72.89     9783.9
 00100   67.44     6152.8
 00200   66.18     3758.6
 00300   63.69     2947.4
 00400   63.32     2484.6
 00500   63.19     2199.4
 00700   63.02     1869.3
 01000   62.15     1631.9
 01300   62.62     1485.9
 01700   62.47     1379.0
 02500   62.06     1273.9
 03500   65.19     1153.6
 05000   65.47     1094.4
 09000   66.75     1024.0
 20000   67.04      984.5

Measuring cache-to-cache transfer latency (in ns)...
Using small pages for allocating buffers
Local Socket L2->L2 HIT  latency        32.0
Local Socket L2->L2 HITM latency        34.9

Which section provides me correct info and if not correct command which should I use?