Jump to content

tips on how to fully fill distro plate

TheDoctor14
 Share
Posted

hello just finished my first clc I can't figure out how to fill this last little bit any tips20231130_183803.thumb.jpg.735585ffdb1f56ddd5205e8eb257bff2.jpg

Link to comment
Share on other sites
Link to post
Share on other sites
Posted
  • Author

its more noticeable in person but it bugs me more than any thing so if there is no fix its all good

 

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

You would need to just rock the PC at about a 45 degree angle so the fill port stays at the highest point and then you can fit a little more fluid in.  You do need to leave some air in the system to leave room for the water to expand with increased temperatures though so unless you have another reservoir somewhere else in the loop you don't want to fill it 100% full.

Link to comment
Share on other sites
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing Custom Loop and Exotic Cooling

×