Jump to content
18 hours ago, Bombastinator said:

So negative pressure can be better than positive pressure but only if you can’t use any filters in which case it is less bad.  Negative pressure might be needed over neutral pressure for temps but would be worse for dust.

As an example the NZXT H500 by default uses negative pressure for pretty good GPU cooling, but mediocre CPU cooling. 

https://www.gamersnexus.net/hwreviews/3309-nzxt-h500-case-review-thermals-noise-vs-s340

Quote

Average GPU temperature in the torture test was 52.4 degrees Celsius with the stock fan configuration, and 53C with the top filter removed, a minor change within margin of error. Interestingly, temperature went up quite a bit with the 140mm intake fan added, up to 59.3C and 58.9C with the 120mm fans moved to front intake. This is where the the stock fan configuration starts to make sense. NZXT chose negative pressure because this allows the GPU to draw air in through empty expansion slots, rather than relying on intake from the mostly-sealed front of the case. When front intake fans are added, even ones pointing towards the GPU, this airflow pattern is disrupted and the GPU can no longer pull cool air in from behind the case.

 

"Put as much effort into your question as you'd expect someone to give in an answer"- @Princess Luna

Make sure to Quote posts or tag the person with @[username] so they know you responded to them!

 RGB Build Post 2019 --- Rainbow 🦆 2020 --- Velka 5 V2.0 Build 2021

Purple Build Post ---  Blue Build Post --- Blue Build Post 2018 --- Project ITNOS

CPU AMD R7 7800X3D    Motherboard Asrock B650E Taichi Lite    RAM Corsair Vengeance RGB 32GB 5200mhz    GPU ASUS RTX4080 STRIX 

Case Fractal Torrent   Storage Samsung 980Pro 2TB, Crucial P3 Plus 4TB x2,     PSU Corsair RM1000x    Cooling Deepcool AK620

Link to comment
https://linustechtips.com/topic/1130064-big-cases/page/2/#findComment-13098114
Share on other sites

Link to post
Share on other sites

2 minutes ago, TVwazhere said:

As an example the NZXT H500 by default uses negative pressure for pretty good GPU cooling, but mediocre CPU cooling. 

https://www.gamersnexus.net/hwreviews/3309-nzxt-h500-case-review-thermals-noise-vs-s340

 

So achingly low temps all round.

Not a pro, not even very good.  I’m just old and have time currently.  Assuming I know a lot about computers can be a mistake.

 

Life is like a bowl of chocolates: there are all these little crinkly paper cups everywhere.

Link to comment
https://linustechtips.com/topic/1130064-big-cases/page/2/#findComment-13098122
Share on other sites

Link to post
Share on other sites

3 minutes ago, Bombastinator said:

So achingly low temps all round.

Keep in mind those are delta's, not actual. (so add about 18-22ºC depending on how cool or warm you have your thermostat set to, usually 20ºC)

"Put as much effort into your question as you'd expect someone to give in an answer"- @Princess Luna

Make sure to Quote posts or tag the person with @[username] so they know you responded to them!

 RGB Build Post 2019 --- Rainbow 🦆 2020 --- Velka 5 V2.0 Build 2021

Purple Build Post ---  Blue Build Post --- Blue Build Post 2018 --- Project ITNOS

CPU AMD R7 7800X3D    Motherboard Asrock B650E Taichi Lite    RAM Corsair Vengeance RGB 32GB 5200mhz    GPU ASUS RTX4080 STRIX 

Case Fractal Torrent   Storage Samsung 980Pro 2TB, Crucial P3 Plus 4TB x2,     PSU Corsair RM1000x    Cooling Deepcool AK620

Link to comment
https://linustechtips.com/topic/1130064-big-cases/page/2/#findComment-13098131
Share on other sites

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×