New build aint working

[Chxttr]

Okay so to make a long story short,

 

I bought a second handed gpu and cpu

Gpu came perfectly nothing to see wrong about it

Cpu had 48 bent pins in total because it was flying all around during shipping

I got them all straightened and it fit perfectly into the socket, And I plugged everyhing out of the case but I couldn't jumpstart the board, it only starts up if the 24 pin isn't plugged in correct but it was to be plugged in at an angle

 

After the fans start spinning and rgb is flashing all around. The the gpu's flashing a small blue LED under the 8 pin conector for the gpu's power, the gpu fans wont spin, it wont output, neither will the mobo so I am really out of idea's here

 

 

Specs

R5 2600

Xfx rx 580 8gb

16 gb ddr4 3000mhz

500w RGB psu 80+ bronze

[Tom Swinden]

if you unbend pins they probably wont work

[Vishera]

7 minutes ago, Chxttr said:

it only starts up if the 24 pin isn't plugged in correct but it was to be plugged in at an angle

That's your problem,This should not happen at all,fix this and the system might work.

[Chxttr]

2 minutes ago, Vishera said:

That's your problem,This should not happen at all,fix this and the system might work.

And how would I go about fixing that?

[Mustangmatt215]

@Chxttr get a new cpu

[Bombastinator]

8 minutes ago, Mustangmatt215 said:

@Chxttr get a new cpu

...and even that might not work.  I’d call this DOA because bad packaging. That you got as far as you did is amazing. 48 bent pins...

[LeeCope3]

Bent pins are not an issue as long as they have not cracked or broke off. It sounds like the 24 pin is the issue