I ran powercfg -a in CMD prompt and need help deciphering

[deeganroma]

The following sleep states are available on this system:
    Standby (S3)

The following sleep states are not available on this system:
    Standby (S1)
        The system firmware does not support this standby state.

    Standby (S2)
        The system firmware does not support this standby state.

    Hibernate
        Hibernation has not been enabled.

    Standby (S0 Low Power Idle)
        The system firmware does not support this standby state.

    Hybrid Sleep
        Hibernation is not available.

    Fast Startup
        Hibernation is not available

 

^That is what pops up. I have been having issues getting my PC to wake from sleep lately and I can't for the like of me figure it out. I think it started after I installed a new m.2 SSD? I'm not entirely sure; it worked for a while then it wouldn't, then it would. I'm now on the longest stretch of having it not work. I wake my PC via keyboard stroke, mouse click or pushing the power button on the PC itself, and it clicks like normal, lights turn on like normal, but the monitors stay black and if I reboot them, they say no signal. My GPU is up to date. 

[Robchil]

it only says it is all disabled in bios, and don't support hibernation sleep or anything at all. 

but it should do normal boot. if you hold powerbutton in 5-8 sec until all goes black and then wait 5 sec before pressing it again. 

the rest is hard to tell, you have this sleep function enabled it some software, or in windows? balanced power scheme or main board software? 

it doesn't say anything about PSU watt, mainboard, cpu ram gpu type etc, hard to tell then.