Pfsense jwplayer problem

[Propphet]

So when i use my pfsense router i get this error on this page

translated its : The requested page is not avalible (jwplayer)

but when i use vpn with pfsense or use isp router it works fine 

so what to do on the pfsense router to fix it

 

http://www.npo.nl/npo3 <- page for if needed

[Eniqmatic]

Do you have any other packages installed or is it a base install with nothing configured?

[Propphet]

Just now, Eniqmatic said:

Do you have any other packages installed or is it a base install with nothing configured?

Youre a genius now the new problem the thing blocks it when i use squid for cache sites i whitelisted npo.nl but still doesnt play withotu squid it does perfectly!

[Eniqmatic]

Its possible that the video does not actually load from that URL. You would need to check the real-time squid logs as you load the page to see what is being requested.

[Propphet]

1 hour ago, Eniqmatic said:

Its possible that the video does not actually load from that URL. You would need to check the real-time squid logs as you load the page to see what is being requested.

I give up looked for over an hower with wireshark blocked over 100th ips still not loading

[Eniqmatic]

Have you looked in the real time squid logs?

[Propphet]

3 minutes ago, Eniqmatic said:

Have you looked in the real time squid logs?

Not to sure where to find them

[Eniqmatic]

Go to squid tab, then real-time tab

[Propphet]

 This one ?

[Eniqmatic]

Yes you need to enable the access logs though to produce anything readable, go back to the first tab, go down till you find the tick box that says "enable access logs" and ensure the location is set to the default (it tells you). Turn this on, then go back to the realtime tab. Now whenever you reload a page, all requested URL's will appear automatically (no need to refresh the pfsense page).

[Propphet]

On 10/1/2016 at 1:34 AM, Eniqmatic said:

Yes you need to enable the access logs though to produce anything readable, go back to the first tab, go down till you find the tick box that says "enable access logs" and ensure the location is set to the default (it tells you). Turn this on, then go back to the realtime tab. Now whenever you reload a page, all requested URL's will appear automatically (no need to refresh the pfsense page).

Oke, next problem the npo.nl stream server gives a new ip all the time is it possible to allow an ip range of do i have to type out all 912385901835 ip adresses because its all the time  195.121. x.x the X changes all the time

[Eniqmatic]

You should be able to do domain name whitelisting rather than IP address.

[Propphet]

Just now, Eniqmatic said:

You should be able to do domain name whitelisting rather than IP address.

no domain 

 

[Eniqmatic]

Ah, that is there problem then. They appear to have hard-coded IP addresses in to the videostream, which is... stupid.

[Propphet]

1 hour ago, Eniqmatic said:

Ah, that is there problem then. They appear to have hard-coded IP addresses in to the videostream, which is... stupid.

So its not possible? i typed in every single ip of them but they still come in the log even the once witch are on the do not cache list

[Propphet]

Well i found it kinda when i turn off  Transparent HTTP Proxy It works fine dont know what it does tho