Looking for waterblock

[EK Luc]

On 9/5/2016 at 8:54 PM, C1intFunWood said:

Hey guys,

 

I'm looking for a cpu waterblocck that will fit in a 1U chassis and with mounting screws like this. but it's a air cooler and I don't know the spacing between the screws 

Do you have the model number of this motherboard?

[C1intFunWood]

2 hours ago, EK Luc said:

Do you have the model number of this motherboard?

DAS97CMB8D0, It's a Cisco UCS c200 M2 server. You probably don't have a block for that, but for the EK Universal GPU Coolers, what is the spacing between the two screws measuring diagonally 

 

[EK Luc]

19 hours ago, C1intFunWood said:

DAS97CMB8D0, It's a Cisco UCS c200 M2 server. You probably don't have a block for that, but for the EK Universal GPU Coolers, what is the spacing between the two screws measuring diagonally 

 

Ok....from the look of it, this board had LGA1366 sockets.

 

If it would have had LGA2011 Narrow ILM sockets, our EK-Annihilator would have been the best since it's meant to be used in 1U Servers.

 

As for the Universal GPU block, I don't know the measurements... I will try to find out.

[C1intFunWood]

 

6 hours ago, EK Luc said:

Ok....from the look of it, this board had LGA1366 sockets.

 

If it would have had LGA2011 Narrow ILM sockets, our EK-Annihilator would have been the best since it's meant to be used in 1U Servers.

 

As for the Universal GPU block, I don't know the measurements... I will try to find out.

 

When you find out, just let me know by PM or here.

 

Thanks for the help!

[C1intFunWood]

6 hours ago, EK Luc said:

Ok....from the look of it, this board had LGA1366 sockets.

 

If it would have had LGA2011 Narrow ILM sockets, our EK-Annihilator would have been the best since it's meant to be used in 1U Servers.

 

As for the Universal GPU block, I don't know the measurements... I will try to find out.

 

Nevermind, I found it, it's maximum size for mounting points is 58x58 which equals 82mm horizontally which is 2.25" .25" too short for the motherboard, I'm going to try and print out the blueprint and see if it works.