Thanks to everyone here

[willmc55555]

Hello everyone. I've been lurking in this forum for about 6 months now and between LTT and Jayz channel, I finally did my own custom water loop. Everyones advice, comments and rants all had a hand in giving me the knowledge to make this happen. It's a white 760t case running an Asus X99 deluxe, a 5930k at 4.5 Ghz, 2 Gigabyte G1 980 ti's at a respectable but not great 1470 boost and an overkill 1300 watt EVGA supernova G2. There's some color mismatching with the fittings and I plan on uncrossing the tubes at the top when I drain the loop in the future. The one thing I'm having trouble with is finding a good mounting solution for the pump/res. It currently sits on top of the screw mounting circle from my old h110, and while I like the look of it, its not very secure, so if someone has any ideas, I'm all ears. Thanks again everyone.

[RuLeZ]

Looks really nice congratz

[DXMember]

can you put screws trough the bottom mesh?

[SeanAngelo]

wow, that looks awesome!

[willmc55555]

can you put screws trough the bottom mesh?

The holes on the bottom vent are too wide though i could use a washer and nut. Problem is that it wont secure the actual pump/res since it just sits on top of the ring.

[willmc55555]

wow, that looks awesome!

Thanks

[willmc55555]

Looks really nice congratz

Thank you! I'm not terribly attached to the way the top gpu power cables look coming out that top grommet, but I like the way it gives the gpus a lift to prevent sag.

[QBtech]

Great looking build! I have the same pump/res combo and I have it mounted to this:https://shop.ekwb.com/ek-uni-pump-bracket-120mm-fan