Need some help

[Yume09]

So since times are though I've been been using an old rig that I'm upgrading bit my bit and rn I've run into an issue 

 

The motherboard is an H81m-k I was using an Intel pentium g3220 before I updated bios and now I'm installing an i5 4460 and I'm getting no display, although when I switch back to the pentium signal comes back 

 

If anyone can help me out with the issue would be much appreciated! 

 

 

 

Full specs :

 

Motherboard : H81m-k

Processor: ehh i5 4460/pentium g3220

Gpu: 1050 ti 4gb

Ram: ddr3 8gb (one stick) 

450w power supply

1tb hdd

[Radium_Angel]

4 minutes ago, Yume09 said:

Intel pentium g3220

I assume you updated the BIOS to something that supports the i5?

[Yume09]

Just now, Radium_Angel said:

I assume you updated the BIOS to something that supports the i5?

Yes I did, I updated the bios to the last possible update.

[Radium_Angel]

Just now, Yume09 said:

Yes I did, I updated the bios to the last possible update.

Are you certain the I5 is good?

[Yume09]

Just now, Radium_Angel said:

Are you certain the I5 is good?

Bought it today, I suppose it is, I also tried an i3 4160 that I had here from another pc which I'm sure works and had the exact same issue 

[KingTdiGGiTTy]

Reset CMOS 

even though updating BIOs should have cleared it, it would be good to try in case there's something preventing a boot.

Have you tried using the integrated graphics when booting with the i5? You might have to set the board to use the DGPU in BIOs.

[Radium_Angel]

1 minute ago, Yume09 said:

Bought it today, I suppose it is, I also tried an i3 4160 that I had here from another pc which I'm sure works and had the exact same issue 

Hmmmm.....

This is a long shot, but have you looked at this

https://forums.tomshardware.com/threads/i5-4690-not-working-on-asus-h81m-plus.3556029/

 

[Yume09]

1 minute ago, KingTdiGGiTTy said:

Reset CMOS 

even though updating BIOs should have cleared it, it would be good to try in case there's something preventing a boot.

Have you tried using the integrated graphics when booting with the i5? You might have to set the board to use the DGPU in BIOs.

I will try right now

[Radium_Angel]

Also this old thread

https://linustechtips.com/topic/540862-problems-with-upgrading-to-i5-4690k-no-post/

 

[Yume09]

22 minutes ago, KingTdiGGiTTy said:

Reset CMOS 

even though updating BIOs should have cleared it, it would be good to try in case there's something preventing a boot.

Have you tried using the integrated graphics when booting with the i5? You might have to set the board to use the DGPU in BIOs.

Tried reseting cmos didn't work still no display I switched the cpu to try and change in the bios to use the DGPU but can't find the function 

[Yume09]

IT'S WORKING! 

 

 

I had to install the old MEI and run the 4th gen bios updater and it  finally worked thank you guys