3080 DRAM error on boot

[Kazmandoo]

Just installed a 3080 FE on my Asus Maximus ROG Formula VIII and I am receiving a DRAM issue (code 53 and dram light is on.) I replaced a custom look 1070 FTW which worked flawless, but was able to get my hand on a FE. 
 

I can boot into win 10 with no GPU and pervious GPU worked the morning before install . I flashed the BIOs to newest update, and have a flesh OS in stall with no files on the Only drive. I reseated all the ram and removed and reinstalled the same Cmos battery. Only thing I can think of is possible bad cable from PSU or dead GPU?

 

6700k custom water loop

32gb 

1000w EVGA PSU

256 m.2 Samsung gen 3 

 

[DoctorNick]

19 minutes ago, Kazmandoo said:

Just installed a 3080 FE on my Asus Maximus ROG Formula VIII and I am receiving a DRAM issue (code 53 and dram light is on.) I replaced a custom look 1070 FTW which worked flawless, but was able to get my hand on a FE. 
 

I can boot into win 10 with no GPU and pervious GPU worked the morning before install . I flashed the BIOs to newest update, and have a flesh OS in stall with no files on the Only drive. I reseated all the ram and removed and reinstalled the same Cmos battery. Only thing I can think of is possible bad cable from PSU or dead GPU?

 

6700k custom water loop

32gb 

1000w EVGA PSU

256 m.2 Samsung gen 3 

 

Update bios. Run at defaults. RUn stock memory (no XMP) and try again

[Kazmandoo]

Thanks for the support tried and still fails. It’s not getting past post and keeps beeping and throwing the same code. No memory. 
 

[Kazmandoo]

4 minutes ago, Kazmandoo said:

 

[DoctorNick]

39 minutes ago, Kazmandoo said:

Thanks for the support tried and still fails. It’s not getting past post and keeps beeping and throwing the same code. No memory. 
 

Do you still have the 1070. I would try putting that in and see if it throws the same error code

[Kazmandoo]

9 hours ago, DoctorNick said:

Do you still have the 1070. I would try putting that in and see if it throws the same error code

Ya I plugged in the 1070 and saw it posted and went straight to the windows opening sequence. But I was showing dram codes then booted. I can’t run test because I do not have any coolant for the loop. But seems to be working fine. I’m going to see if a friends MB will post with it.