CPU temp are too high for custom loop

[Zyad1421]

Hey everyone! I hope everyone is good and safe.

(first custom loop!) (gpu not included in loop)

I think im getting really high temps. I built a custom loop for my cpu last week, i was very excited to see my new temps. i did some tinkering in my bios to learn more about OCing. i finally set my cpu to 4.8GHz at 1.35(i think). Everything was going great and stable, but my temps were very high. when I realbench my cpu max temp reaches 88C. i think thats too high ever for an AIO!

after further inspection i found out that my loop has a ton of air bubbles, i removed most of them and temps somewhat improved. However there is a ton of tiny bubbles in my res, when i set my pump to 100% these tiny air bubbles swirl around the inlet port and make the res foggy, is this normal?

 

This is a pic of realbench and pump/res:

https://imgur.com/gallery/PubsXdl

 

[5x5]

Intel runs hot these days. 88 for 4.8GHz at high voltage is very normal

[Hairless Monkey]

I see you are running a 6700K.

 

That voltage may be more than you need for 4.8Ghz, but 88C is not unusual even on a custom loop when OCing.

 

You might consider looking into De-lidding. You can drop your temps by up to 20C, but results vary.

[SpookyCitrus]

The 6700k is known to get quite hot when OC'ing mainly due to high voltages, if you are going to be running it OC'd even with the custom loop it would be a good idea to delid the processor. 

[Vishera]

Temps are a bit toasty but they seem normal.