Question On a case

[Weeds]

Hello everyone and good day! I have a question about a case cause i would transfer all my PC components in a different case and its a E-ATX. I’m asking about the Lian-Li 011 dynamic XL if all my PC parts will fit especially my motherboard and my 2 GTX 1080Ti FE thanks and all my pc specs is down below.

 

(PC Specs)

MOBO: Asus x99 deluxe II
PROCIE: intel i7 6800k
AIO: corsair h115i
RAM: corsair dominator 64gb w/ fan kit
GPU 1: ASUS GTX 1080 Ti FE
GPU 2: EVGA GTX 1080 Ti FE 
PSU: corsair ax1200i
SSD 1: Corsair  MP500 M.2 120GB (OS)
SSD 2: Samsung 860 Evo 1TB
HDD 1: Seagate Barracuda 2tb (RAID 0 Configuration)
HDD 2: Seagate Barracuda 2tb (RAID 0 Configuration)

[Quadrum]

I’ve got the non-XL variant of this case, and that one can hold what you’ve mentioned. On mine an EATX motherboard might have issues if you put a distro plate on the side fan mount like I did, but other than that very niche use case, the non-XL should work fine for you.

 

I have to check the heights of the gpus, and I’ll get back to you on that

[Quadrum]

3 minutes ago, Quadrum said:

I’ve got the non-XL variant of this case, and that one can hold what you’ve mentioned. On mine an EATX motherboard might have issues if you put a distro plate on the side fan mount like I did, but other than that very niche use case, the non-XL should work fine for you.

 

I have to check the heights of the gpus, and I’ll get back to you on that

The gpus will fit, hope all goes well!

[Weeds]

1 minute ago, Quadrum said:

The gpus will fit, hope all goes well!

Thanks for that man, i was suppose to get the corsair air 740 but it is currently out of stock. About the distro plate I don’t have plans for getting one cause i have no idea on putting on a water block. 

[Quadrum]

1 minute ago, Weeds said:

Thanks for that man, i was suppose to get the corsair air 740 but it is currently out of stock. About the distro plate I don’t have plans for getting one cause i have no idea on putting on a water block. 

I was just using that to point out that the EATX fits but it kinda unwieldy in the case. It’s officially supported but the rightmost inch or so of the board goes past the tray, which in my case, makes me go ATX. You really aren’t going to see any issues to my knowledge.

[darkknight302]

Are you sure your mobo is not atx? I'm not familiar with it but it says it's a atx. I have that case and the H115i if it's a atx it and everything else you have should fit with ease in it. Lian Li says a eatx should fit in there but I'm wondering if you might have to take off the side rubber grommet to get it to fit. I have a picture of my system with the 1080ti in sli.

 

 

[Weeds]

46 minutes ago, darkknight302 said:

Are you sure your mobo is not atx? I'm not familiar with it but it says it's a atx. I have that case and the H115i if it's a atx it and everything else you have should fit with ease in it. Lian Li says a eatx should fit in there but I'm wondering if you might have to take off the side rubber grommet to get it to fit. I have a picture of my system with the 1080ti in sli.

 

 

 

Not really sure but i asked around about my motherboard majority of people who I’ve asked said that it is a E-ATX. Will know in a bit if i will remove the rubber grommet cause already ordered one. Heres a picture of my rig on corsair air 740.

[darkknight302]

It looks like it's atx from the picture so I'm guessing it should be ok. The picture is kinda dark.
This is what my case looks like with my 2080ti with the powerlink. I see you got the powerlink too so it should look good in it. 



 

[TVwazhere]

20 hours ago, Weeds said:

 

Spoiler

 

The ASUS X99 Deluxe II is an ATX board

https://www.asus.com/us/Motherboards/X99-DELUXE-II/specifications/

 

You could probably fit all this in the original version.