ASUS ROG Crosshair VI Hero

[Martines91]

Hi,

so I finished my build, and until I make few modifications to the case I can't use my H110i (doesn't fit in mastercase maker 5t)

but my question is, when I power up my PC the AMD wraith cooler and the ROG motherboard RGB lights go in perfect sync, right after bios and before windows logon screen they go out of sync and the AMD cooler looses the blue spectrum, showing only red and kind of dimmed green (very low light) what is happening? does anyone know? yesterday when I updated the system software wise it went back again, but today when I started the system the same thing has happened. also ROG AURA does not recognize the header, I've tried both headers and it is connected accordingly (arrow to the 12V) if needed I can provide a video, thanks

[Salacious B Crum]

5 minutes ago, Martines91 said:

Hi,

so I finished my build, and until I make few modifications to the case I can't use my H110i (doesn't fit in mastercase maker 5t)

Can I ask what doesn't fit about it? I have that case, that cooler and that board and it fit albeit I did reconfigure the hard drive cage but that's a breeze with this case

[Martines91]

it doesn't fit to the top, I haven't tried mounting it to the front, though I was considering it, but I don't like the fact that hot air would be blown in

[Salacious B Crum]

Just now, Martines91 said:

it doesn't fit to the top, I haven't tried mounting it to the front, though I was considering it, but I don't like the fact that hot air would be blown in

I see did you try to install the fans first into the tray then mount the radiator onto the fans? if I remember correctly that would work but its been awhile so I may be wrong on that?

[Martines91]

do you mean the tray being outside? because that way it is super easy, but I can't put it inside from the top due to the riveted handle that blocks the radiator, then I tried it by having the fans touching the tray and trying to fit the screws, but they're too short (I'm going to buy longer ones and trying that) also, on the inside of the case there are two rails, and the radiator has two notches, in which I assume the rails would go, but the radiator's notches are too short, the spacing doesn't fit, I can fit one side but then the radiator is sloped, I can barely center the radiator not sloping but then as I said the screws are too short, but this is a whole nother topic, back to my non working LED lights

[Martines91]

bump, it's still bugged

[Salacious B Crum]

4 hours ago, Martines91 said:

bump, it's still bugged

Here's what mine looks like so your saying the 2 RGB strips are not showing? 1 of 2 things come to mind either there is an issue with the pins both on the board or the plug and therefore it's not being detected or for whatever reason the software is buggy which I have experienced with this software as a test I would uninstall all traces of the software and load the previous version to see if that corrects it or changes in any way