How To Gain My New Microphone?!
36 minutes ago, amazinjoe555 said:As you probably know, the 2i2 isn't the most reliable for playing live...
Let's just say their drivers are a bit buggy. And from what I've heard with a pretty obvious reason.
So, your setup isn't providing a very satisfactory experience. Let's try to fix that.
To start with we'll disconnect the mixer from the 2i2 and just focus on getting that set up properly. Start by turning both the channel and master faders to zero [I know they're pots on that board but i'll use 'faders' because otherwise i'll get confused]. Make sure the phantom power switch is on and the mic is properly connected. Just above the channel fader, there's a light labelled 'OL' ['over-limit' aka clipping, which is a bad thing], while speaking/singing from a normal use position (which should be fairly close to the mic, into the front [yes it has a front, and remember it's side address]) bring the channel gain up until the light begins to flash, then take it back slightly. You want to set it so that you're loudest sound is slightly under the clip level.
Two methods for the next step. Either put the channel fader or the master fader to 0 dB (or unity, marked with a 'u' on your board) and then use the other to adjust the level so that it's somewhere between -6 and 0 dB. Usefully, the Mix12FX has a basic VU for the output so you can use that to judge the setting.
Before connecting the mixer to the 2i2, set the gain to 0dB on both channels, make sure phantom power is off, both inputs should be set to line inputs. One nice feature of the Focusrite interfaces is that they have a nice green light which comes on when they detect an input, hopefully you've now got two lights around the gain knobs. We want to find that magic value again, 0 dB, but they don't have it nicely labelled so shoot for something halfway-ish-maybe. Another good feature is that the nice green lights turn red when you're overloading the input. So once again aim for a level where it's somewhere beneath that level. If you find that you can't add any gain in the focusrite before it clips then slightly lower the level on the mixers master fader.
That should solve any issues you're having with the level of the mic, and clean it up a bit as well. Once it's set as the default device within windows you should be off to the races. If it's quiet in certain programs then there will be a volume setting somewhere in the program, and i think there will still be the option to set an input level from within windows recording devices, if you go into the properties for the device.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now