Fan Setup + Push / Pull

[Propphet]

So what to do with intake / outtake and what do do with the Corsair H115I push / pull or both 

i got an intel i7 4820k @ 4.2ghz and an gtx 770 all hdd drives are full.

in the Purple slot i can hotglue an 120 / 140 mm fan what i already got 

current setup : back 120mm outtake - frontt 120 mm intake -top 2X 120 mm outtake - diy 120 mm intake - back 80mm outtake -

the dred quars in the middle of the case is the left side pannle there are no fans

[Cyracus]

a rad setup as a pull config makes cleaning much easier, push/pull might allow you to run the fans quieter though....can't remember testing though, certainly doesn't help overall thermals all that much. Of course the rad blows out the top and if you have filters for the intake I'd do the front and the bottom side panel, don't really need the extra fan stuck in the front, but you do you. If you can't filter the intakes, well might as well put that rear exhaust fan and edge yourself into negative pressure

[Propphet]

8 hours ago, Cyracus said:

a rad setup as a pull config makes cleaning much easier, push/pull might allow you to run the fans quieter though....can't remember testing though, certainly doesn't help overall thermals all that much. Of course the rad blows out the top and if you have filters for the intake I'd do the front and the bottom side panel, don't really need the extra fan stuck in the front, but you do you. If you can't filter the intakes, well might as well put that rear exhaust fan and edge yourself into negative pressure

Soo i can do pull with easyer cleaning or do push / pull with intake filters and run fans on lower rpm

 

Filters like those once ? https://www.amazon.co.uk/SilverStone-SST-FF143B-ultra-Filter-Magnet/dp/B00B69JAOQ/ref=sr_1_1?ie=UTF8&qid=1479116033&sr=8-1&keywords=140mm+filter

[Cyracus]

yeah those should work, or at the very least help