Custom cooling loop help

[TimboSlice58]

So im finally bending my tubing for my loop and I'm wondering if anyone has used the EKWB FC Terminal triple parallel?  There are two ports on the top and I was wondering if both ports are the same? Using the port on the right would be more ideal for me since it lines up almost perfectly with the CPU block fitting.  Anybody have any experience with the terminal?

[W-L]

3 minutes ago, TimboSlice58 said:

So im finally bending my tubing for my loop and I'm wondering if anyone has used the EKWB FC Terminal triple parallel?  There are two ports on the top and I was wondering if both ports are the same? Using the port on the right would be more ideal for me since it lines up almost perfectly with the CPU block fitting.  Anybody have any experience with the terminal?

They are not the same for the parallel unit you must use the left port and either the right hand side one or one on the side for proper flow.

https://www.ekwb.com/shop/EK-IM/EK-IM-3831109868089.pdf

[givegomezthegun]

^^

 

But, if you wanted the water coming in the bottom to be on the left side, you could have it come out the right at the top where it's directly below your cpu.

[TimboSlice58]

6 minutes ago, givegomezthegun said:

^^

 

But, if you wanted the water coming in the bottom to be on the left side, you could have it come out the right at the top where it's directly below your cpu.

Ok thanks for the help.  Looks like ill just make an extra bend