Sliverstone SG13 question

[Guest]

If you own the case can you please measure the area of the top PSU vent as I want to buy the case and I want to buy a 140mm fan dust filter to make sure the PSU will have filtered air. So can you please measure it? Thanks. 

[Enderman]

uuuuuuuh

if you buy a 140mm fan filter, it will be 140mm.....

all 140mm fan filters are 140mm

 

if a 140mm fan fits in the case, then so will a 140mm filter

[Guest]

uuuuuuuh

if you buy a 140mm fan filter, it will be 140mm.....

all 140mm fan filters are 140mm

 

if a 140mm fan fits in the case, then so will a 140mm filter

Yes I know that. But the point is the PSU intake is not  a place where you mount fans. That's why I'm asking the area of it to see if I can fit a 140mm fan filter on it,

[Enderman]

Yes I know that. But the point is the PSU intake is not  a place where you mount fans. That's why I'm asking the area of it to see if I can fit a 140mm fan filter on it,

its not a square vent

its a rectangle

 

a 140mm square fan filter will cover the middle of it but leave space on the sides

the best way to get full coverage would be two 120mm fan filters and remove 1cm from one side of each filter

then that would perfectly cover that vent

 

or buy a custom fan filter

[MourningSouls]

I don't know of any off the shelf filters that will suit your needs. You could look at custom filters, or add a little bit of effort when it comes to cleaning and just buy a filter that matches the side of your PSU and attach it directly.