BitFenix Prodigy M Case Mod

[NzlHD]

Hello, First Pc build and I thought the Prodigy M would be a good case, Really liked the design and compactness.

I watched a few reviews on it and knew it had flimsy feet, When  got it they were a lot more flimsy then I thought.

Anyway, I took it to a Lan-Party and one of the bottom sides broke. So I set about thinking of ways to make it look nice again.

 

Here is what i came up with:

 

I managed to find some feet off a couple of old record players. had a look at the bottom of the case and there are already screw holes in the four corners of the bottom of the case.

So I found some screws that fit and screwed into them. They worked nicely, I will look at buying some fancier feet later on.

 

Now there was only the issue of the ugly holes that the case leaves when the oem foot is taken off. so I cut it up, I sanded it down and fit it again.

Doesn't look too bad, better then without them.

 

 

 

[MattWakey]

Good job that's awesome, might end up doing this to my prodigy

[NzlHD]

Thanks, If i were to do it again I would make the plastic bits on the side a little longer and have them curve around the body more.