People with screwdriver and extra bits

[bobbybdennis]

I purchased the screwdriver and all of the bits to go with it just so i could have a complete set, 4months later everything shows up but i don't really have a good way to store them, has anyone 3d printed a holder for everything? i keep the screwdriver in my pocket, any good holders for the plethora of other bits i have now lol ?

[Alinz]

If the bits are standard (which i believe they are) you could always just buy a cheapo set, throw the bits out and put yours in there.

 

or you could purchase something like this:

 

 

 

[tkitch]

They're a standard sized shank, just shorter.
So any normal driver bit holder will work fine for them.

 

[manikyath]

they're a standard bit size, just a bit shorter to fit in the shaft.

 

you can just 3D print a bit holder with *slightly* undersize holes, or print with oversize holes and a magnet at the base, depending on how fancy you want to get.

 

i've designed and 3D printed my own screwdriver 'as a joke' around the LTT screwdriver launch, and used both of those ideas: one for the tip, and one for the bitholders. it's been good so far, not that i use a screwdriver with bits very often because i only ever use 4 sizes, and i have all 4 in an full screwdriver form.