PC not booting up properly

[nazul]

Hello!

MY PC SPECS:
CPU - Ryzen 5 2600x
MOBO - MSI X370 SLI PLUS
RAM - G.Skill 2133MHZ 16GB x2 8GB Sticks (yes I know ram is a bit meh for this build)
GPU - RX 570 4GB
SSD - 2x Samsung 870 EVO 1TB  

I have a issue with my pc. Woke up went on my pc for about 3 hours turned it off, went back on it the same day about 6 hours later, won't start up. I open up the case, see a EZ Debug LED light was on for VGA. Previously I had this issue, I had to keep switching around the ram sticks until it booted properly. I did the same in this case but no luck, I reset CMOS, still nothing, but when I switch the ram and put in the right position slot 2 and 4 CPU and DRAM lights would come on and then it would keep boot looping. Eventually after about an hour, 1 ram stick in slot 1 worked and it booted completely fine, so I turned it off, and install the 2nd ram stick in the 3rd slot, boot it up again and back to square one, VGA light has come on. 

Does anyone know a fix to this ? Because I am currently thinking about getting a new mobo, ram and cpu to fixed this issue since ive had many issues with this board. 

[Bombastinator]

1 hour ago, nazul said:

Hello!

MY PC SPECS:
CPU - Ryzen 5 2600x
MOBO - MSI X370 SLI PLUS
RAM - G.Skill 2133MHZ 16GB x2 8GB Sticks (yes I know ram is a bit meh for this build)
GPU - RX 570 4GB
SSD - 2x Samsung 870 EVO 1TB  

I have a issue with my pc. Woke up went on my pc for about 3 hours turned it off, went back on it the same day about 6 hours later, won't start up. I open up the case, see a EZ Debug LED light was on for VGA. Previously I had this issue, I had to keep switching around the ram sticks until it booted properly. I did the same in this case but no luck, I reset CMOS, still nothing, but when I switch the ram and put in the right position slot 2 and 4 CPU and DRAM lights would come on and then it would keep boot looping. Eventually after about an hour, 1 ram stick in slot 1 worked and it booted completely fine, so I turned it off, and install the 2nd ram stick in the 3rd slot, boot it up again and back to square one, VGA light has come on. 

Does anyone know a fix to this ? Because I am currently thinking about getting a new mobo, ram and cpu to fixed this issue since ive had many issues with this board. 

There is a no POST no screen thing in the pinned posts in troubleshooting that may help you.  Is it no post or just no screen?  Also is your bios up to date?  Memory does just suddenly go bad occasionally. Usually just one stick of a kit though. Will it boot with the other stick in slot one?

Edited November 1, 2022 by Bombastinator