PSU shroud question

[wes1099]

I was looking into making a PSU shroud for my corsair carbide 300r, I have measurements, but I don't know what kind of metal I need, where to get it, or how thick it should be. Could someone please help?

[RelentlessAF]

You could look at the specifications of other PSU's I'm sure Corsair or SeaSonic post the gauge of the metal and it's type.

[wes1099]

I don't think you understand what I am asking. I want to make something like what is on this thread: http://linustechtips.com/main/topic/89468-simple-psu-cover-shroud-how-to/

I pm'ed the guy who started the thread about 5 days ago and he hasn't responded...

[W-L]

I'd probably suggest if your using sheet metal something around 22-24 gauge, which should be pretty easy to bend and cut by hand. They should carry galvanized sheet metal at most hardware stores like Lowe's or Home Depot. 

[B NEGATIVE]

I was looking into making a PSU shroud for my corsair carbide 300r, I have measurements, but I don't know what kind of metal I need, where to get it, or how thick it should be. Could someone please help?

 

1-1.2mm Alu and a sheet metal brake is required...or a work bench,you can clamp the sheet in there and use the clamp as the brake.

 

Or....

 

This is a simple guide to forming 90's on acrylic sheet,you can make curves and other shapes with the use of formers but im keeping this simple for the novice..

This is what you will need for this guide.

The plexi/acrylic of your choice

A heat gun.

A work bench or surface

A set of clamps and a clamping block to hold the workpiece in place.

First up,line the edge of the worksurface with the line of your bend on the workpiece.

then place your clamping block in line with your chosen bend point.

Select 'FULL POWAH' on your trusty heatgun..

Then move along the bend line,i keep around 3" away fro the plexi and move very quickly back and forth.

Push gently with your fingers until the workpiece lays flat at 90 then maintain pressure for a couple of minutes.

While the plexi is hot,it will have a springy property to it and will try to open up.

You can tighten the 90 up even more using a former  to push  the acrylic down.

The end result is this..

PSU covers or hide away panels are now easy to make.

You can tighten the 90 up even more using a former  to push  the acrylic down and in to the worktable.

Please do this kind of thing in a ventilated space,preferably outdoors,as gasses are released on heating of acrylic...you cant see or smell them but they are there.

Take fire precautions  when using heat sources in this way.

 

 

Sidenote: You should use the search.....

[wes1099]

I'd probably suggest if your using sheet metal something around 22-24 gauge, which should be pretty easy to bend and cut by hand. They should carry galvanized sheet metal at most hardware stores like Lowe's or Home Depot. 

Thanks! I will go look at Home depot/lowes. What kind of paint do i need?

[W-L]

Thanks! I will go look at Home depot/lowes. What kind of paint do i need?

If your looking to spray paint it make sure to sand and clean parts thoroughly making sure to remove oils from finger prints and dust before using a metal primer first before your top coats, allowing them to dry thoroughly in between coats.

 

In general something like an enamel works really well on metal and is pretty good with abrasion or wear.

[_T3CHKN0_]

I got one made and it was made of galvanized steel. Downside is you can't spray paint it with average spray paints so it is easier to use Vinyl Wrap or get it painted professionally. But I'm pleased with mine.