Will it it

[mikeeginger]

Hi does any one know if you can fit four Noctua NFF 12's on a h100i in a c70 vengeance on a ASUS P8Z77?

[Dave :)]

You should be alright, there is ample clearance in the C70; however, you may just snag a top of one of the VRMs on the motherboard - i can't be sure. What board exactly are you getting?

[airdeano]

dave hit it directly, asus P8Z77 boards of different levels have different MOSFET heat sinks.

if you measure from the top row of motherboard stand offs to the roof, you are looking for a

minimum clearance of 77mm (2x 25mm fans and 27mm for rad). have you tried under-volting

the OE fans, yet?

 

airdeano

[dasr1985]

are the noctua fans that much larger or is the mobo that different?  I know with my Z77A MSI mobo i can't run push/pull but as far as normal set up clearance I have tons of room between the RAD and my mobo.

[Ghost]

are the noctua fans that much larger or is the mobo that different? I know with my Z77A MSI mobo i can't run push/pull but as far as normal set up clearance I have tons of room between the RAD and my mobo.

They are by a few mm. Check the noctua site for dimensions and measure against what you have now.

[Ghost]

are the noctua fans that much larger or is the mobo that different? I know with my Z77A MSI mobo i can't run push/pull but as far as normal set up clearance I have tons of room between the RAD and my mobo.

They are by a few mm. Check the noctua site for dimensions and measure against what you have now.

[AP01ARB3AR]

Depending on your mobo and case, issues with the 8pin may arise