Question about building a loop.

[LaboonTheWhale]

So i just received my stuff to build a watercooling loop.

 

Can I just put the pump and everything together and let the water flow or should I rinse out the inside of the Rad's and other blocks out with water (then rinse again with distilled) to make sure its absolutely clean before i build it? 

[madscientist56]

Not a bad idea but I don't really think it will make all that much of a difference.

[FlakeyBanana]

You can, sometimes stuff front the manufacturing process gets left in. A small bit vinegar is normally used

[FlakeyBanana]

The important thing to do is to make sure that you don't run your pump dry!!,!,!,

[ciprian97pop]

no need for this

[Prophet of Entropy]

I use a small in-line filter while flushing my loops, but this is mainly to collect cat hair.... >.<  it's everywhere!!!....

[Altecice]

Take the RAD and boil a kettle, fill it up and leave it for a few moments and then pour the water out... SOOO MANY people don't do this and it causes small bits of rubbish to float around your loop and into a waterblock.

[Thecrazyswede]

Take the RAD and boil a kettle, fill it up and leave it for a few moments and then pour the water out... SOOO MANY people don't do this and it causes small bits of rubbish to float around your loop and into a waterblock.

 

this, and it can fuck your pump up.

[LaboonTheWhale]

Take the RAD and boil a kettle, fill it up and leave it for a few moments and then pour the water out... SOOO MANY people don't do this and it causes small bits of rubbish to float around your loop and into a waterblock.

I shall do this. Thanks!