First time watercooling, need help.

[ZakeyKyle]

So, I'm doing my first Hard Line watercooling loop between a CPU and a GPU (1080 Strix) however I'm getting a this kit along with this GPU Block however I'm going to have to buy extra fittings and stuff. Which parts am I going to need to ensure this is fully working (EK parts please!) 

[Sreno1]

I don't think rubber tubes count as a hard line water cooling solution.

[ZakeyKyle]

Just now, Sreno1 said:

I don't think rubber tubes count as a hard line water cooling solution.

I forgot to say, I'm not using the tubes! I'm getting EK acrylics 

[Himommies]

You need new fittings for hardline but other then that a heat gun if you are bending or just a lot of right angle fittings

[ZakeyKyle]

Just now, Himommies said:

You need new fittings for hardline but other then that a heat gun if you are bending or just a lot of right angle fittings

What size fittings though, I assume it's the same as the tubing? 

[Himommies]

Just now, ZakeyKyle said:

What size fittings though, I assume it's the same as the tubing? 

Well what size tubing are you using

[ZakeyKyle]

1 minute ago, Himommies said:

Well what size tubing are you using

13/10mm. 

[Himommies]

https://www.ekwb.com/shop/fittings/compression-fittings/for-10-13mm-3-8-1-2-tubing

Get about 8 of these assuming your bending

[ZakeyKyle]

2 minutes ago, Himommies said:

https://www.ekwb.com/shop/fittings/compression-fittings/for-10-13mm-3-8-1-2-tubing

Get about 8 of these assuming your bending

Thank you!