Jump to content

building a new Computer for myself and the family. so far I have:

 

thermaltake Chasar A71 case (full tower)

EVGA G1 750W PSU (yes I know it's a G1... (will try it for now, then possibly upgrade to the G2, or bigger should the SLI980 need it)

Gigabyte Z170A UD5 mobo

Cooler master H212 cpu cooler

 

still to order (waiting on tax return.

Sm951 256gb M.2 SSD in RAID 0, or I may just go with 1 Samsung 950 PRO 256gb.

i7 6700K

16GB of corsair Vengeance LPX 2x8GB sticks (black), leaving upgradeable to 32GB.

1 500GB SSD scratch drive (dunno which one, doesnt have to be lightning fast, just a scratch drive for editing/short term storage before going onto my 4TB+ NAS, or getting burned.

 

this will comprise the system and will run with onboard graphics until I build up a little scratch to buy either a 980ti (future SLI), or Titan X(single) with a decent 4k monitor. waiting on new releases from AMD/NVIDIA.

Link to comment
https://linustechtips.com/topic/571075-black-magic/
Share on other sites

Link to post
Share on other sites

got my Samsung 950 Pro 256GB M.2 drive.. this thing is BLAZING fast.. here's a crystal disk screenshot. now to setup windows on this machine to my liking.. lots of work to come.

 

install was super simple. other than the tiny screw used to screw down the drive. (also very close to my CPU cooler.. I definitely recommend installing an M.2 before you install the CPU cooler unless you have a good magnetic screwdriver (small). 

samsung Pro950.jpg

Link to comment
https://linustechtips.com/topic/571075-black-magic/#findComment-7525884
Share on other sites

Link to post
Share on other sites

ok so I'm lost. system is running great, have been able to do a mild overclock for 4.6gightz. and have been attempting to enable XMP on the memory, but am not able to get the rated 3000mhz out of the system. was only able to get 2600-2800mhz. not a huge deal, but am a bit puzzled. I'm assuming I'll have to attempt timing changes, but a little leary about delving into that right now.

 

I attempted to load an old HDD into the top Sata hot swap port on the case (hooked into SATA port 0 on the MoBo (M.2 uses the PCI bus, second M.2 slot disables/shares bandwidth with PCIX4 slot). and I have enable ACHI on SATA ports as well as hot swap on 0. windows will not recognize it. it has an old windows install on it, planning to wipe it and use it as a scratch drive.

 

any ideas.

Link to comment
https://linustechtips.com/topic/571075-black-magic/#findComment-7531080
Share on other sites

Link to post
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×