Positive Air Pressure

[keleja]

Any suggestions on how to configure my current components for positive air pressure? I know I am not configured like that now and could use some advice on an optimal setup. Below is my current config.

 

Case:

be quiet Silent Base 800 (no window; has 1 fan mount on each side panel, both are filtered)

 

Intake (front - filtered):

2 be quiet Pure Wings 2

 

Exhaust (unfiltered):

2 Corsair SP120Ls (top; h100i)

1 be quiet Pure Wings 2 (rear exhaust)

 

PSU Fan (bottom filter):

Corsair AX860i Fan facing down

[W-L]

2 minutes ago, keleja said:

-SNIP-

I would suggest to add an extra fan at the bottom as intake or to either keeping the three exhaust fans always close to idle and have the fronts run at a higher speed making it so that the intake volume is higher than exhaust.

[OddsCrazyStuff]

Optional Fan Installation

Top (mm)

2 x 140/120

Bottom (mm)

1 x 140/120

Side panel (mm)

1 x 120

 

if you install the 2 top once, put the one on the bottom and side panel in as well.

Since the fans on the h100i should not be turned down too much.