Need GPU and Wireview pro 2 help

[Sir Judgementz]

ok so i need you guys help again. was playing the division 2 and i got up to go eat dinner. after i got back i got a unbalanced current warning on my wire view pro 2 with my msi gaming trio oc 5090 gpu. i cleared the warning, checked for updates to both the software and firmware for the wire view, and ran two more Furmark test. Tis one is the video i attached, test two is the csv with 1 min of idle before and after the test. Was this just a bug or something? also is a highest recorded current of 9.387A on Pin 6 ok? and 1.6A spread from lowest to highest pin ok. this is also with a undervolt of 0.935@2805 and these test was Furmark again

wireview Data.csv

[OddOod]

I'd reseat the cables (on both sides) and hope that it was just a fluke. It could be something as simple as a stray radio wave hitting a trace and throwing a faulty reading.
While reseating, spend a minute inspecting the connectors (plug and socket) with your phone light. Look for any warps or folds

[seon123]

On 4/28/2026 at 5:03 AM, Sir Judgementz said:

also is a highest recorded current of 9.387A on Pin 6 ok?

It's fine. The current rating per pin is 9.2A for the Molex connector, and 9.5A for the Amphenol one, and that's the current needed through all the pins simultaneously for the temperature to reach 20°C above ambient temperature. 

[Sir Judgementz]

is a different from the lowest pin to the highest on the 5090 cards ok with up to a 1.5amp different? if say pin 2 is 4.50 and pin 6 is 6.00  or if a pin 1 is 7.8 and pin 5 is 9.3 thats ok?  was told that 1.5 amp different is really the highest to be considered safe.

[SansVarnic]

-= Merged =-

Continue in original thread, no need to repost.