Boot Cycle after SLI bridge install

[Wmbailey96]

I sold my rtx2080ti to buy a new 30 series (RIP), and my friend gave me two gtx 760s to hold me over. both are properly installed and my computer posts and runs normally. It isnt till i try to boot with both cards linked with an SLI bridge that my pc gets trapped in a boot cycle. any ideas? i wondered if the second card is dead, however, it wouldnt boot in the first place if it were dead, correct?

[TeraBot452]

check bios settings and make sure your board supports sli.  On intel its mostly z and x series boards.  And on AMD basically only x series boards support SLI

[Wmbailey96]

2 hours ago, xXGaming123 said:

check bios settings and make sure your board supports sli.  On intel its mostly z and x series boards.  And on AMD basically only x series boards support SLI

Z390 mobo

[--SID--]

20 minutes ago, Wmbailey96 said:

Z390 mobo

Which exactly. Not alle Z390 boards support SLI.

 

What's the make and model of your psu?

[Wmbailey96]

29 minutes ago, --SID-- said:

Which exactly. Not alle Z390 boards support SLI.

 

What's the make and model of your psu?

Rog hero maximus (5/6?)

Seasonic 750w. Not too sure w model spec