Jump to content

ender 3 pro bltouch firmware update

Sub2pewdiepie
By Sub2pewdiepie
in Hobby Electronics
 Share
Posted

I have just recently purchased the ender 3 pro and a bltouch upgrade for the 3d printer. I am trying add the bltouch to my ender3 pro which has the new 32 bit board through an sd card. I followed a tutorial for an ender 3 v2 which has the same board. On my sd card i downloaded the latest bl touch software from crealitys website which downloaded a BIN file, which is what is needed. When I put the sd card into my ender 3 pro it took a while for the logo on the lcd to show up which is normally what would happen when you flash the system but then the speaker began beep violently. Looking at the printer all of the software was uploaded successfully and my bltouch tabs were seen but the speaker will not quite. Im wondering if I did something wrong updating the printer or if that can be stopped somehow. 

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

can you link where you bought it, i need to know which version you have to help.

Link to comment
Share on other sites
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing Hobby Electronics

×