Motherboard+fans

[2552Jordan]

Fan controller: 4 piece fan controller hub

Motherboard: B450 tomahawk max atx

 

I was wondering if the motherboard fan headers could dupply enough power through one port to power 4 non rgb fans bitfenix 120mm fans?

Or

Will i need something else to make this work?

 

thank you

[2552Jordan]

links to all in the underlined words

[Haro]

the tomahawk already has 4 pin pwm headers, no need for a controller or  a splitter/ fan hub.

[2552Jordan]

5 minutes ago, TofuHaroto said:

the tomahawk already has 4 pin pwm headers, no need for a controller or  a splitter/ fan hub.

I was going to fill all the spaces in my case so that would be 8 fans needed.

zalman s2

(ps i know i can get this case chesper when i buy it but it is the cheapest it shows on pc part picker)

[Haro]

10 hours ago, 2552Jordan said:

I was going to fill all the spaces in my case so that would be 8 fans needed.

well usually a single fan header can handle a total of 1A,  so check how many fans you can plug in one header.

or you could just get a splitter and plug 2 fans to one header, and that should be under 1A and should work just fine.

any pwm splitter will work just fine and they go for cheap usually.

[2552Jordan]

each fan is about 0.3 amps so a 3 fan splitter is sufficient and less likely to fry the port.

Thanks