High CPU temps

[gurannsan]

I have a ryzen 5 3600x running with stock coolers on stock settings, but after a few minutes of running at 80-90% it gets temps around 90°-95°. When I had just got the CPU I ran benchmarks to check how much the difference was to the old ones, and the temps went up to 95°+ and the computer shut down. Do i have to buy a new cooler, or is it just enough to reapply the termal paste?

 

 

 

[Stormseeker9]

Are you sure that the cooler is tightly secured, enough thermal paste? As the stock ryzen should cool adequately for a non oc stock 3600

[The_russian]

The stock cooler should be fine, especially if you are not overclocking. Make sure you are using enough thermal paste and that you have enough mounting pressure.

[gurannsan]

How do i check the mounting pressure?

 

[The_russian]

10 minutes ago, gurannsan said:

How do i check the mounting pressure?

 

You can’t really check it, just make sure you tightened the screws for the cooler tight enough.

[gurannsan]

[bronsonj]

i know its the stock cooler but nuctua says .5nm or 4 ish inch lbs 

what i do is use a screw driver and tighten it till it is tight/ wont turn easy and give it a quater turn

[SavageNeo]

downloa ryzen master and manually set your voltage to 1.35-1.38

[gurannsan]

Just now, SavageNeo said:

downloa ryzen master and manually set your voltage to 1.35-1.38

Will this lower performance?

[SavageNeo]

2 minutes ago, gurannsan said:

Will this lower performance?

no, but gen3 ryzen often has too high voltage. Lower voltage= less heat.

You can also set your cores to 4-4.4ghz. This makes your cpu run at those clocks all the time.

[SavageNeo]

How good airflow you have (intake fans? outtake fans?) because your gpu is 72c wiht only 4% load?

[gurannsan]

I have one intake and one outake fan. I think the gpu is high because im running FAH and it's using the gpu. Temps went up as soon is i launched it but there were no signs of usage. I'm guessing this is just flaws in the software or something.

[gurannsan]

The mode on ryzen master was manual so i thought i light have messed with some settings there so I set it on default settings but then after a restart without doing anything it went to like 80 degrees and powered off. Now I can’t boot at all without a crash. Is there any way to change the voltage in bios?

 

Edit: I can boot now at 50-60 degrees. Guess it was just overheated to start with. At idle it lies at 50 boost up to 55-60 and slowley goes down to 50 btw. It has done this since i got it, as well as getting the high temps. It is now locked at 1.01 volts too, but it seems like the temps are still the same. I will try to reapply the termal paste, and if that doesnt work I'll just buy a new cooler or something.