Entering BIOS

[Matfill]

I am doing a new build and when I power the PC it says "Enter the set up to restore BIOS settings." But it fit say to press F1 or anything like that. I was pressing F2 to enter bios while the boot but it didn't work. I pressed F1 on enter set up page but it didn't work. There's no way to enter bios.

[LIGISTX]

2 minutes ago, Matfill said:

I am doing a new build and when I power the PC it says "Enter the set up to restore BIOS settings." But it fit say to press F1 or anything like that. I was pressing F2 to enter bios while the boot but it didn't work. I pressed F1 on enter set up page but it didn't work. There's no way to enter bios.

Delete is usually how you enter the BIOS... sometimes on first boot it says say press F1, but just try Delete instead.

[Matfill]

4 minutes ago, LIGISTX said:

Delete is usually how you enter the BIOS... sometimes on first boot it says say press F1, but just try Delete instead.

Same thing. Keyboard lights up and it says keyboard detected but it doesn't work

[thedangerine]

What are you system specs, most importantly your cpu and board

[Matfill]

57 minutes ago, thedangerine said:

What are you system specs, most importantly your cpu and board

I7 9700k

MSI 2080ti

Asus Rog Strix z930-E

I tried 2 different keyboards and nothing happens. It just turns off after 15 seconds.

[thedangerine]

Try clearing the cmos and see if that changes anything, can be done by removing the battery on the board just below the PCIe slot for about 15 seconds or so. Make sure its powered off before you do that tho

[Matfill]

9 minutes ago, thedangerine said:

Try clearing the cmos and see if that changes anything, can be done by removing the battery on the board just below the PCIe slot for about 15 seconds or so. Make sure its powered off before you do that tho

Already did that, same thing. It says set up is required but doesn't say what to press. Usually it say like press F1 for a set up. 

[thedangerine]

If you can find a PS/2 keyboard that may be your only hope, will work without drivers and I have never had an issue with it not working. My first built had this issue as my usb keyboard would just not work without drivers

[Danioki]

try pressing ENTER , in some systems that stop the post process and give you options for boot.