Power And Reset Wire Headers.

[AbuEl3eesSensei]

Sup guys, I need some help
so im planning on getting a remote for my pc it connects to a 9 pin usb 2.0 internal header (which is available) and it comes with power and restart cables now the USB 2.0 part is self explanatory, but the power and restart cables, i dont know where to put them, since i'd like my front panel buttons to work

 

if u could help id really appreciate it!

[emosun]

splice them into the buttons then

[manikyath]

with some careful wiggling, you can get a paperclip in the back of one of those connectors, so you can "daisychain" one connector off the other.

[EsaT]

Those are meant to connect to motherboard's pin header for power and reser button of case.

But unless you connect them in parallel buttons of case won't work.

Not sure if there are any ready splitters for connecting wires of two "buttons" to one header.

 

This kind PCB breadboard/prototype board wires with female connector in one and and male in other could be used to make splitter cables:

https://www.digikey.com/product-detail/en/sparkfun-electronics/PRT-12794/1568-1511-ND/5993859