Kraken x42 in custom loop.

[Codychris]

I am looking to make a full nzxt build with as much of there stuff as possible, (big fan of it). But I want to also incorporate a custom loop for it all. So what I want to know I'd the water block copper or aluminum, also the Id and OD of the tubing. I want to do a hard line build. Plz help and thank you as well.

[Bananasplit_00]

im pretty sure hardline cant be done, those are barb fittings on the pump and i doubt you can remove them. like you could do a little bit of soft and then hardline, but that would be pretty janky

[Codychris]

45 minutes ago, Bananasplit_00 said:

im pretty sure hardline cant be done, those are barb fittings on the pump and i doubt you can remove them. like you could do a little bit of soft and then hardline, but that would be pretty janky

Well..... dang. I may have to figure something out then ugggg. Thank you!!

[andrewmp6]

I wouldnt try most aio have a pump just big enough to run as is,So adding to it will be a bad idea,Its best just to bite the bullet save up and go fully custom loop.

[Codychris]

15 hours ago, andrewmp6 said:

I wouldnt try most aio have a pump just big enough to run as is,So adding to it will be a bad idea,Its best just to bite the bullet save up and go fully custom loop.

ya it was pretty much going to be fully custom, i just love the rgb waterblock, i love nzxt lol. and was hoping to incorperate it in the loop. but alas i cant . i decided on everything and have to do with out ughh

 

[andrewmp6]

A lot of companies make a rgb cpu waterblock,Like thermaltake xspc have blocks that light up but you can't see through.If you want see through and rgb you got a long list thumb around http://www.performance-pcs.com/#