Cpu error

[Camtron84]

Hey guys I have a rizen  1600 and a kraken 62 motherboard is strix 370x and I get a cpu  error and my temps go to 90 just at start  screen I have everything connect I felt the pump feels like it's on I have the rad in push pull in a phanteks  p400 not sure what iv done wrong...

 

[just_dave]

do you have the latest BIOS?

[OdivValknir]

Do you have your pump plugged into the cpu fan header?

[Camtron84]

I do have the latest bios  and there is 3 connectors by the cpu and I have it into the aio  pump header that my mother board has 

 

[Camtron84]

Also I took the cooler and and mad3 sure it's getting contact and re applied thermal paste 

[Santo22]

Just sent my kraken x62 back for the same reason. If you can go into bios and see what the pump rpm is I bet any money the pump is not working. If it shows in bios a speed of anything around 400-500 it means the pump is shot. Or if you bypass the CPU error by turning it off in bios and load windows, go to cam software and see if the pump rpm is reporting 0. Let us know as this seems to be a very common issue with the x62 right now. 

[Camtron84]

5 hours ago, Camtron84 said:

Also I took the cooler and and made sure it's getting contact and re applied thermal paste 

Alright I'll look into that once I'm off work thnx guys 

[Camtron84]

Hey so I checked in my bio and it's showing my rpm around 2000/3000 for my aio  pump  I'm stumped on what the problem could b3 turn the system on and it's at about 30c and ramps up to 90c....  anyone have any clues....

[Santo22]

do you have the CAM software installed? What does CAM show the RPM of the pump at? If bios is reading it I would imagine the pump is working, but I'm wondering what CAM shows and if at any time the pump is cutting out. If that's not the problem only other thing that comes to mind is if you are overclocking or not? I would imagine you'd have said if you adjusted voltage at all. When you remove pump from CPU is the paste spread well? As in, is it making good contact with chip?

[Camtron84]

sorry late to updating yes the paste spread was good and the cam software would show the pump working around 2000 3000 rpm same with bio and no no overclocking all stock but i did notice there was not much sound and vary little vibration from the pump and i could not feel much movement in the water pipes i got it from newegg so iv sent it back see what they say for now im using my stock fan but now i have a hole new problem lol.... mouse keyboard and monitors all shut off at random but pc stays on but im locked out nothing lets me get back to the computer have to hard reset...