Custom Modded PC

[rowanhazard]

Hello everyone, its my first time back on these forums in a while, so go easy on me!

 

I am thinking about a new build, hopefully something like this: https://pcpartpicker.com/user/rowanhazard/saved/#view=RxnNGX .

 

I was hopefully going to make ITX and use the Phanteks enthoo evolve case (https://www.newegg.com/Product/Product.aspx?Item=N82E16811854016&ignorebbr=1&nm_mc=KNC-GoogleAdwords-PC&cm_mmc=KNC-GoogleAdwords-PC-_-pla-_-Cases+(Computer+Cases+-+ATX+Form)-_-N82E16811854016&gclid=CjwKEAiA_p_FBRCRi_mW5Myl4S0SJAAkezZr82mtvBKY8nSSJxyGHHZyH_ksUi3PWLmgQ5JgooW_qRoCLIrw_wcB&gclsrc=aw.ds)

 

that didn't have a window (this is going to be a hackintosh). I then thought about how cool it would look to have little acrylic lines going down the case illuminated by RGB LEDs, but how hard would it be to do that? Ex:

 

 

 

So basically what Im asking is how hard would it be to cut lines (and insert acrylic) into a evolv ITX case?

 

Thanks in advance.

[fuzzymonkey10]

Probably should have put this in the pc modding section 

[rowanhazard]

52 minutes ago, fuzzymonkey11 said:

Probably should have put this in the pc modding section 

Good point. Like I said, I'm new  

[fuzzymonkey10]

23 minutes ago, rowanhazard said:

Good point. Like I said, I'm new  

just looking at this again mabey if you could get rgb tubes and drill holes at the top angle and drop them through it