NZXT 440 Side window Mod opinion pls

[Woofly94]

Instead of forking out couple hundred quit for a new case, I was wondering if it would be cheaper to actually modify my NZXT 440 to what I would be buying a new case for, which is to see the watercooling reservoir, with my current case NZXT 440, You can't see the reservoir unless you look where the drive bays are, and ofcourse there is a side panel that blocks that.

 

So I was wondering if I could get some opinions on what I should do, I have only spent 10 minutes or so thinking so forgive me if my ideas are stupid.

I havent thought about if doing any of this would cause structural problems because like I said I've only just thought about it. 

 

Also forgive me for such crap pictures, I am using a GoPro to take the pictures and the only way to not get a blurry pic is to use a light source for the shutter speed but w/e.

 

1st, Extending the whole panel to edge with no bezel

2nd, cutting the panel and fitting another window showing reservoir with everything else, I'm not that keen on this one because it will PSU show cables.

3rd, cutting the panel and fit a small window to show the reservoir, this shows exactly what I want to see without seeing everything else, there will be a little bezel between the 2 windows for a nice little design

 

Also bear in mind there is drive bay mount wall thingy that will need to be cut out aswell depending on the window type I do.

 

Any suggestions welcome, as said before I've only thought this over for like 10 mins.

 

 

[shadowbyte]

http://www.overclock.net/t/1548599/build-log-nzxt-h440-build-and-mods-leviathan

[Woofly94]

8 minutes ago, shadowbyte said:

http://www.overclock.net/t/1548599/build-log-nzxt-h440-build-and-mods-leviathan

Thanks but that mod doesn't actually help me as I can't do that mod, because I have a 64mm thick in the front, so pretty much the only mod I can do is to cut a little window to show the reservoir, do you also know the best tool to get clean cuts? I'm completely new to this