Inwin h-frame mini PSU Size!

[Authon]

Does anyone happen to now the form factor of this Power Man PSU. I would like to replace it with a 350 - 400 watt one but i haven't been able to figure out the size  I don't know if it's even possible to get one with that wattage considering the dimensions  

[TheRandomness]

Most likely a Flex ATX PSU. You can get a 400W one from Athena Power (it's actually decent).

[Authon]

24 minutes ago, TheRandomness said:

Most likely a Flex ATX PSU. You can get a 400W one from Athena Power (it's actually decent).

Thanks!

[79 Potatoes]

30 minutes ago, TheRandomness said:

Most likely a Flex ATX PSU. You can get a 400W one from Athena Power (it's actually decent).

It's proprietary, half the size of flex ATX. I've that PSU... and looking at the H-frame that case can't be modded for flex ATX, other cases like the BM650 and such can by ommiting the PCI covers. For higher power in that case OP would probably need a DC to DC PSU though thinking about it that case can only fit up to single slot low profile GPU so... the current PSU will support any configuration .-.

So unless the OP is trying to cram a 6950X + GT 610 (which would be silly) then there's no point on changing the PSU

[Authon]

1 hour ago, 79 Potatoes said:

It's proprietary, half the size of flex ATX. I've that PSU... and looking at the H-frame that case can't be modded for flex ATX, other cases like the BM650 and such can by ommiting the PCI covers. For higher power in that case OP would probably need a DC to DC PSU though thinking about it that case can only fit up to single slot low profile GPU so... the current PSU will support any configuration .-.

So unless the OP is trying to cram a 6950X + GT 610 (which would be silly) then there's no point on changing the PSU

I was planning on using the evga gtx 1060 sc. Mount it in a vertical position with a pci express riser on a custom aluminium side panel to make the case a bit wider. The only thing i need is a psu with a higher wattage than the one currently in the case, while still keeping the small form factor.

[79 Potatoes]

1 minute ago, Authon said:

I was planning on using the evga gtx 1060 sc. Mount it in a vertical position with a pci express riser on a custom aluminium side panel to make the case a bit wider. The only thing i need is a psu with a higher wattage than the one currently in the case, while still keeping the small form factor.

Look how to fit flex atx in the current PSU place, a flex ATX PSU should be the same as 2.

I mean, look on the sides of the case if with the new dimesions something ~10 cm wide would fit. A possible problem would be PSU lenght

http://www.newegg.com/Product/Product.aspx?Item=N82E16817151128