Define R4 Case cables

[Kaita]

Hello! I just finished building my PC and installed windows 10 and looked at cpu temp etc and everything's good. Now I want to connect the front panel and case fans but Fractal doesn't really say anything about that in the manual. I connected the USB , HD Audio , Power LED but I can't figure out how to install the power button because it doesn't have the + and - signs. Another problem is the case fans , I connected a molex power to the fans but they don't work , do I need to connect them to the motherboard? Thanks in advance.

[Samppa221]

For the fans there is a control switch behind the front door in the upper left corner. The power button doesn't matter witch way you put it.

[rhyseyness]

The orientation doesn't matter for the power button as it's just a switch.

As for the fans, are you using a molex to 3/4 pin adapter?

I'd recommend you plug them into the motherboard as you have now way of controlling their speed if they're straight into the PSU.

Hope this helps!

[Kaita]

-nvm-

[Kaita]

The orientation doesn't matter for the power button as it's just a switch.

As for the fans, are you using a molex to 3/4 pin adapter?

I'd recommend you plug them into the motherboard as you have now way of controlling their speed if they're straight into the PSU.

Hope this helps!

I still don't know where to put On the manual there's PWRBTN and GND next to it , should I put them there?

[rhyseyness]

I still don't know where to put On the manual there's PWRBTN and GND next to it , should I put them there?

What motherboard is it?

[Kaita]

What motherboard is it?

Asrock Z170 Extreme4

[rhyseyness]

ftp://europe.asrock.com/manual/Z170%20Extreme4.pdf

Go to page 30, section 2.6.

Connect the front panel connector between PWRBTN# and GND.

Hope this helps.

So yes, do as you said earlier, using PWRBTN and GND

[Kaita]

ftp://europe.asrock.com/manual/Z170%20Extreme4.pdf

Go to page 30, section 2.6.

Connect the front panel connector between PWRBTN# and GND.

Hope this helps.

So yes, do as you said earlier, using PWRBTN and GND

That worked! Thanks One last question , will this cable management work? I could reroute the CPU power to the back but I'd leave it like that for the time being , Any dangers from leaving it like that? http://i.imgur.com/65yk0go.jpg

[rhyseyness]

That worked! Thanks One last question , will this cable management work? I could reroute the CPU power to the back but I'd leave it like that for the time being , Any dangers from leaving it like that? http://i.imgur.com/65yk0go.jpg

That will be fine