fx8320 and h105 problem

[evanny]

Hello people of Linus forum. Today i was planing to show off my rig but ran into problems. I installed h105 on my m5a99x evo r2 board with fx8320 cpu. Did it since i wanted to just do some upgrade with 550d case i bought. So long storry short, pc doesnt boot up ( and yesterday it did, only change is the case and h105)

in that 1 second it did boot for more than a sec, i managed to see text abot new cpu or something, then it went black. Now it doesnt beep or anything..just spins fans for2 seconds. So. Could it be there is special way for connecting pump and fans of h105? I have both fans with Y connector on cpu fan slot, pump on cpu opt.

Thank you.

[Joshyy]

Hello people of Linus forum. Today i was planing to show off my rig but ran into problems. I installed h105 on my m5a99x evo r2 board with fx8320 cpu. Did it since i wanted to just do some upgrade with 550d case i bought. So long storry short, pc doesnt boot up ( and yesterday it did, only change is the case and h105)

in that 1 second it did boot for more than a sec, i managed to see text abot new cpu or something, then it went black. Now it doesnt beep or anything..just spins fans for2 seconds. So. Could it be there is special way for connecting pump and fans of h105? I have both fans with Y connector on cpu fan slot, pump on cpu opt.

Thank you.

 

You have the molex plugged in, correct?

 

Ignore above, the H105 doesn't have a Molex like the H80 does, it sounds like the pump on the H105 is dead if it's cutting out instantly.

[Sintezza]

replace the H105 with the stock AMD cooler, and try if its booting then.

 

just to determine if its pump related, or  not.

[evanny]

Hahaha. Turns out u just have to use chasis fan pins for pump