PC not posting?

[Tokishi]

I just recently bought these parts for a computer I am building however, no images or even the bios can be seen on any monitor I hook it up to.

Methods I have tried-

Move the ram sticks from the 1 and 2 to 3 and 4 slots and use 1 ram stick.-nothing

Hooked it up to the graphics card and see if anything popped up.- nothing

Remove the graphics card and hook the monitor to the motherboard.- nothing

I have double-checked with connectors to see if anything is loose.- Nothing

Though the motherboard has a red light.

 

Things I know as of right now

I have to hold on to the power button to turn it off (normally on my other computer if its not going right it is a 1 tap and it turns off.)

All fans work and the hard drive is functional.

 

Not sure if I used the wrong connections for the parts or if I didn't put something in the right place I am unsure what is going on.

 

 

--The graphics card is a PNY GTX 4060--

8GB GDDR6 128-bit Memory

7680 x 4320 Maximum Resolution

PCIe 4.0

Full Height, Dual Slot

DisplayPort 1.4a, HDMI 2.1

 

 

Power Supply is.

RMx Series™ RM1000x — 1000 Watt 80 PLUS Gold Fully Modular ATX PSU

[kb5zue]

Hello,  Ram should be in slots 2 and 4.  I'm not saying that is the fix, but I do know that your ram should be in 2 and 4.  Are the top two cables for the cpu connected?  Top left-hand corner of the mobo.  Should be two - 8 pin power connectors in the top left corner connected to power but can't make it out in the picture, too dark there.  Maybe a better pic would help.

 

Take care and good luck.

[podkall]

I see you have a DDR5 system,

 

if it's your first time turning it on, try letting the PC sit turned on for few minutes

 

could be the RAM training, especially if the red light is for DRAM issue

[Starlight28]

Maybe try and reset the BIOS? there should be a jumper on the motherboard somewhere. you can also remove the CMOS battery.

[Tokishi]

I have fixed the ram sticks and now the VGA light is currently on. In the top corner its a 4 and a 6 pin