Long Screwdriver for installing a Peerless Assassin 120, which length and head ?

[PDifolco]

I'm wanting to test a Peerless Assassin 120 cooler, will replace the meh fans with a couple Arctic P12 Pros

I'd then check if I can have same perf than a 280mm watercooling with reservoir, and it should be close !

 

Yet while I have a lot of PC tools (ifixit set) aI have no long screwdriver for installing this cooler, and there's none as accessory like Noctua does..

So what length and head do I need ? 

[filpo]

4 minutes ago, PDifolco said:

I'm wanting to test a Peerless Assassin 120 cooler, will replace the meh fans with a couple Arctic P12 Pros

I'd then check if I can have same perf than a 280mm watercooling with reservoir, and it should be close !

 

Yet while I have a lot of PC tools (ifixit set) aI have no long screwdriver for installing this cooler, and there's none as accessory like Noctua does..

So what length and head do I need ? 

Very sure its four headed as seen on the official product page for the cooler and you would need a fairly long screwdriver (all lengths are in mm)

[IkeaGnome]

2 minutes ago, filpo said:

its four headed

Phillips. 
Probably a number 1 or number 2. 
 

If @PDifolcohas a Noctua screwdriver it should work just fine. 

[filpo]

10 minutes ago, IkeaGnome said:

Phillips. 
Probably a number 1 or number 2. 
 

If @PDifolcohas a Noctua screwdriver it should work just fine. 

ye ofc I don't know the name

[PDifolco]

10 minutes ago, IkeaGnome said:

Phillips. 
Probably a number 1 or number 2. 
 

If @PDifolcohas a Noctua screwdriver it should work just fine. 

Yep I know it's a Phillips not sure Nr1 or 2, and what "blade" length  I need

Noctuas is PH2 but I don't have one, will maybe just buy it

 

[freeagent]

You shouldn't need anything special, you are not going into the fin stack like on something like Le Grand Macho RT. I am using my Thermalright screwdriver