Looking for Cable

[melody]

I wasn't sure this was the right forum, but I'm searching for a cable that is compatible with the Sharp IR sensor GP2Y0D02, with one end for connection to the sensor and one free end. This is for a device that will work as a counter.

[Needfuldoer]

I think it's just a 3-pin JST connector.

 

https://www.amazon.com/Micro-Connector-150mm-Cable-Female/dp/B01DUC1PW6

 

Does it match this datasheet?

https://media.digikey.com/pdf/data sheets/sharp pdfs/gp2y0d02yk.pdf

[mariushm]

According to the datasheet : https://image.dfrobot.com/image/data/SEN0014/gp2y0a21yk0f.pdf

The sensor uses a JST PH series (S3B) header .. so you need a cable with JST PH connector at least on one end. 

 

 

Cable ( JST PH plug - JST PH plug - you can cut one end to have loose wires at one end) : https://www.digikey.com/en/products/detail/adafruit-industries-llc/4336/10650639

 

Pre-crimped wires (wire with contact, need housing to insert the wires in ) : https://www.digikey.com/en/products/filter/jumper-wires-pre-crimped-leads/453?s=N4IgTCBcDaIFIGUAqACACgCRAXQL5A

 

Housing (the plastic connector in which you insert the crimped wires) : https://www.digikey.com/en/products/detail/jst-sales-america-inc/PHR-3/527357

Sadly out of stock, Digikey recommends and considers TE/AMP HPI series as substitute so it should work and there's 85k in stock : https://www.digikey.com/en/products/detail/te-connectivity-amp-connectors/440129-3/2077919

 

Individual connectors (you'd need crimping tool) : https://www.digikey.com/en/products/filter/rectangular-connectors-contacts/331?s=N4IgTCBcDaIFIGUAqACACgCRAXQL5A

 

Other distributors .. Mouser , Farnell / Newark , TME.eu , RS Components etc .. search for JST PH series or that TE/AMP HPI series plug.